Difference between revisions of "KTM 500 EXC"

From Mtc
Jump to navigationJump to search
Line 8: Line 8:
 
* [http://www.rekluse.com/coreexp.shtml Recluse Core EXP]: $900 retail, SBM? + about 90min to install.  Do at an oil change.
 
* [http://www.rekluse.com/coreexp.shtml Recluse Core EXP]: $900 retail, SBM? + about 90min to install.  Do at an oil change.
 
* [http://www.gprstabilizer.com/prod_v4_dirt GPR steering damper] $495 (KTM EXC 13-14 Fat Bar: 9001-0078) $450@SBM.
 
* [http://www.gprstabilizer.com/prod_v4_dirt GPR steering damper] $495 (KTM EXC 13-14 Fat Bar: 9001-0078) $450@SBM.
−
* [http://www.globetrottin.com/Skid-plate--Composite-full-coverage-for-KTM-500-EXC-XCW_p_23.html Skid Plate]
+
* Skid Plate:
 +
** [http://www.globetrottin.com/Skid-plate--Composite-full-coverage-for-KTM-500-EXC-XCW_p_23.html RTE Skid Plate] $140 made of carbon/fiber/epoxy.
 +
** [http://www.tmdesignworks.com/index.php?main_page=product_info&cPath=325_327_354&products_id=973 TM Designs] skid plate at $105.  Plastic but sounds solid.  Not quite as much coverage as the RTE tho.
 
* [http://slavensracing.com/shop/super-mini-fuel-filter-kit-by-golan/ Golan Fuel Filter] $60 for filter and clamps.  Use this to replace the small stock inline filters which tend to clog and stall the bike.
 
* [http://slavensracing.com/shop/super-mini-fuel-filter-kit-by-golan/ Golan Fuel Filter] $60 for filter and clamps.  Use this to replace the small stock inline filters which tend to clog and stall the bike.
 
* [http://www.woodyswheelworks.com/KTMMotardWheels.html Woody's Wheels]... ends up around $1900 for a "best" supermoto set of wheels.
 
* [http://www.woodyswheelworks.com/KTMMotardWheels.html Woody's Wheels]... ends up around $1900 for a "best" supermoto set of wheels.

Revision as of 21:48, 25 January 2014

500 EXC Issues

  • cold clutch doesn't fully disengage.
  • "shimmy" starting around 50mph which gets a little worse w/ more speed and settles into a cyclic on/off shimmy.
    • Balance the wheels, 3oz in front and 3.75 in rear.

Parts

  • Fuel filter sock, put in tank cap area as a pre-filter.
  • Recluse Core EXP: $900 retail, SBM? + about 90min to install. Do at an oil change.
  • GPR steering damper $495 (KTM EXC 13-14 Fat Bar: 9001-0078) $450@SBM.
  • Skid Plate:
    • RTE Skid Plate $140 made of carbon/fiber/epoxy.
    • TM Designs skid plate at $105. Plastic but sounds solid. Not quite as much coverage as the RTE tho.
  • Golan Fuel Filter $60 for filter and clamps. Use this to replace the small stock inline filters which tend to clog and stall the bike.
  • Woody's Wheels... ends up around $1900 for a "best" supermoto set of wheels.
  • LiteLock Rim Locks Cheap and lighter than stock, light enuf that you shouldn't need to balance the wheels according to some folks. 1.6 front and 2.15 rear.
  • DoubleTake Mirrors around $93 for a pair. I've also seen mirrors which fold into the hand guards, would like to compare the pros/cons of the Double Takes w/ those.
  • DirtTricks Cone Washer and rear sprockets and front sprockets $37: apparently these last long and are the way to go.
  • Acerbis Tanks
  • AP Racing PRF Brake Fluid: Apparently the best for not boiling.
  • Tires:
  • Wheels:
    • Warp9 around $1K for a full setup including rotors and caliper spacer. These sound like they're a good bang/buck but might not hold up to extreme abuse.
    • DNA Wheels, similar to the Warp9's.
    • Some recommend steering clear of the "Chinese Crap" and going with excels/rad/talons. ...and "this was on cs.

17"-Black Excell rims with gold Talon hubs and heavy duty custom spokes. Dunlop race slicks on wheels contact Brandon (209) 577-2873"

  • Mousse/Bibs for going "airless", need to research pros/cons of this more. Sounds like they're heavier, do wear out, can generate heat...

Forums and Info

Retrieved from "http://wiki-mtc.eri.ucsb.edu/index.php?title=KTM_500_EXC&oldid=627"