Difference between revisions of "KTM 500 EXC"

From Mtc
Jump to navigationJump to search
Line 18: Line 18:
  
 
===Forums and Info===
 
===Forums and Info===
 +
* ADVRider forum thread: [http://www.advrider.com/forums/showthread.php?t=746534 500 EXC as a lightweight adventurer]. Lots of good info in this thread.
 
* ADVRider forum thread: [http://advrider.com/forums/showthread.php?t=607184&page=223 on LED Lights].
 
* ADVRider forum thread: [http://advrider.com/forums/showthread.php?t=607184&page=223 on LED Lights].
 
* ADVRider Forum thread: [http://advrider.com/forums/showthread.php?t=834105 500 EXC Less is more?] started by neduro
 
* ADVRider Forum thread: [http://advrider.com/forums/showthread.php?t=834105 500 EXC Less is more?] started by neduro

Revision as of 12:49, 22 January 2014

500 EXC Issues

  • cold clutch doesn't fully disengage.
  • "shimmy" starting around 50mph which gets a little worse w/ more speed and settles into a cyclic on/off shimmy.
    • Balance the wheels, 3oz in front and 3.75 in rear.

Parts

  • Fuel filter sock, put in tank cap area as a pre-filter.
  • Skid Plate
  • Golan Fuel Filter $60 for filter and clamps. Use this to replace the small stock inline filters which tend to clog and stall the bike.
  • Woody's Wheels... ends up around $1900 for a "best" supermoto set of wheels.
  • LiteLock Rim Locks Cheap and lighter than stock, light enuf that you shouldn't need to balance the wheels according to some folks. 1.6 front and 2.15 rear.
  • Mousse/Bibs for going "airless", need to research pros/cons of this more. Sounds like they're heavier, do wear out, can generate heat...
  • DoubleTake Mirrors around $93 for a pair. I've also seen mirrors which fold into the hand guards, would like to compare the pros/cons of the Double Takes w/ those.
  • DirtTricks Cone Washer and rear sprockets and front sprockets $37: apparently these last long and are the way to go.
  • Acerbis Tanks
  • AP Racing PRF Brake Fluid: Apparently the best for not boiling.
  • MT21 50/50 tires: recommended by Chris at SBM.

Forums and Info